|
|
|

Phihong’s POE80U-560(G) is a 80W high temperature range, Ultra Power Single-Port midspan injector, functionally compliant to the IEEE802.3af standards but with 4-pair injection and 12.5KΩ handshake detection. This midspan injector is suitable for powering both PoE enabled devices and non-PoE enabled devices, with the use of a PoE splitter, via Cat5e/Cat6 cable into 10/100/1000 Base T systems.
Applications
| Computer workstation | Wireless Network Access Points |
| LCD Display; Kiosk | Satellite Receiver |
Features
| Fully Compliant with IEEE802.3af | Single Source 4 Pair Power Current Sharing |
| Diagnostic LEDs; Gigabit Compatible | Full Protection OCP, OVP; Broken wire detect |
Output
| DC Output Voltage | Pair1: +56V / Pair2: +56V |
| Load | Pair1: Min. 0A; Max. 0.72A/ Pair2: Min.0A; |
| Regulation | Line / Load: 54-57VDC under all conditions |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1min. 10mA |
| Primary to F.G. | 2121VDC for 1 minute | |
| Output to F.G. | 2121VDC | |
| Insulation Resistance | Primary to secondary | >10M OHM 500 VDC |
| Primary to F.G. | >10M OHM 500 VDC |
Input
| AC Input Voltage Range | 85 to 264 VAC |
| Leakage Current | 3.5mA max @ 254 VAC 60 Hz |
| AC Input Frequency | 47-63 Hz |
| AC Inrush Current | 50A (RMS) max. for 115VAC/ 20A(RMS) max. for 230VAC |
| AC Input Current | 1,25A for 90VAC / 0,9A for 240VAC |
General
| Efficiency | 75% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 10mS min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V max. at switch on &off at any point on AC line phase |
| Ripple and Noise | <500Hz (Vp-p:0,5mV); 500Hz-150KHz (Vp-p:0,15mV) |
| 150KHz-500KHz (Vp-p:0,15mV); 500KHz-1MHz (Vp-p:0,1mV) |
EMC
| Conducted & radiated Emission | FCC Part 15 Class B | ||||||||||||||
| EN55022 Class B | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation -40 to +55°C Non-operation -50 to +85°C |
| Humidity |
| Operation 5 to 90% |