|
|
|

Phihong’s POE60U-560(G) is a 60W Ultra Power Single-Port midspan injector, functionally compliant to the IEEE802.3af standards but with 4-pair injection and 12.5KΩ/ 25KΩ handshake detection.
The midspan injector is suitable for powering both PoE enabled devices and non-PoE enabled devices, with the use of a PoE splitter, via Cat5e/Cat6 cable into 10/100/1000 Base T systems.
Applications
| Satellite Receiver; Computer workstation | LCD Display; Kiosk; Wireless Network Access Points |
Features
| Fully Compliant with IEEE802.3af; Gigabit Compatible | Single Source 4 Pair Power Current Sharing |
| Diagnostic LEDs; Broken wire detection | Full Protection OCP, OVP; Non-Vented Case |
Output
| DC Output Voltage | Pair1: +56V / Pair2: +56V |
| Load | Pair1: Min.0A; Max.0.55A/ Pair2: Min.0A; Max.0.55A |
| Regulation | Line / Load: 54-57VDC under all conditions |
| * Note: XX refer to VC model that is available with 25K detection. Standard model offers 12.5K detection. | |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1min. 10maA |
| Primary to F.G. | 2121VDC for 1 minute | |
| Output to F.G. | 2121VDC | |
| Insulation Resistance | Primary to secondary | >10M OHM 500 VDC |
| Primary to F.G. | >10M OHM 500 VDC |
Input
| AC Input Voltage Range | 90 to 264 VAC |
| Leakage Current | 3.5 mA max @ 254 VAC 60 Hz |
| AC Input Frequency | 47-63 Hz |
| AC Inrush Current | 30A (RMS) max for 115VAC/ 40A (RMS) max. for 230VAC |
| AC Input Current | 2A for 90VAC / 1,2A for 240VAC |
General
| Efficiency | 75% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 10ms min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V max. |
| DC Offset | No data degradation with DC imbalance 18mA per min. |
EMC
| Conducted & radiated Emission | FCC Part 15 Class B | ||||||||||||||
| EN55022 Class B | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation 0 to +40°C Non-operation -25 to +65°C |
| Humidity |
| Operation 5 to 90% |