   |
|
POE36U-1AT
Single Port 33.6W Midspan PoE Injector
Beschreibung
Phihong’s POE36U-1AT is a 33.6W PoE Single-Port midspan injector, fully compliant to the IEEE802.3at standards. This midspan injector is suitable for powering both PoE enabled devices and non-PoE enabled devices, with the use of a PoE splitter, via a Cat5e/ Cat 6 cable into 10/100/1000 Base T systems. It’s compliant with IEEE802.3at and backward compatible with IEEE802.3af.
Eigenschaften
Applications
| IP Telephones ; Wireless Network Access Points | Security Camera with Pan/ Tilt/ Zoom |
| Bluetooth Access Points | IP Print Servers |
Features
| Gigabit Compatible | Cisco AP1250 Series compatible; |
| Diagnostic LEDs; Non-Vented Case; | UNH IOL tested; Full Protection OCP, OVP |
Output
| DC Output Voltage | 33.6W @ 56 V |
| Load | Min. 0A / Max. 0.60A |
| Regulation | 54 - 57 VDC under all conditions |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1min. 10mA |
| Primary to F.G. | 2121VDC for 1 minute | |
| Output to F.G. | 2121VDC | |
| Insulation Resistance | Primary to secondary | >10M OHM 500 VDC |
| Primary to F.G. | >10M OHM 500 VDC |
Input
| AC Input Voltage Range | 90 to 264 VAC |
| AC Input Frequency | 47-63 Hz |
| AC Inrush Current | 30A (RMS) mx for 115VAC/ 40A (RMS) max. for230 VAC |
| AC Input Current | 1,0A for 90VAC / 0,55A for 240VAC at max. load |
General
| Efficiency | 78% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 16mS min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V max. at switch on and off at any AC line phase |
| Ripple and Noise | <500Hz (Vp-p:0,5mV); 500Hz-150KHz (Vp-p:0,15mV) |
| 150KHz-500KHz (Vp-p:0,15mV); 500KHz-1MHz (Vp-p:0,1mV) |
EMC
| Conducted & radiated Emission | FCC Part 15 Class B | ||||||||||||||
| EN55022 Class B | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation -20 to +50°C Non-operation -20 to +65°C |
| Humidity |
| Operation 5 to 90% |