   |
|
POE30U-560(G)-HT
Single Port 30W Midspan PoE Injector
Beschreibung
Phihong’s POE30U-560(G)-HT is a 30W high temperature range Single-Port midspan injector, functionally compliant to the IEEE802.3af standards. This midspan injector is suitable for powering both PoE enabled devices and non-PoE enabled devices, with the use of a PoE splitter, via a Cat5e/ Cat 6 cable into 10/100/1000 Base T systems.
Eigenschaften
Applications
| IP Telephones / IP Print Servers; Security Camera | Blue Tooth Access Point; Wireless Network Access Points |
Features
| Wide operation temperature range of -20 to +55°C | UNH IOL tested; Full Protection OCP, OVP |
| Diagnostic LEDs; Non-Vented Case | Gigabit Compatible; Fully compliant to IEEE802.3af |
Output
| DC Output Voltage | 56 V |
| Load | Min. 0A / Max. 0.55A |
| Regulation | 54 - 57 V DC under all conditions |
| DC Offset | No data degradation with DC imbalance 18mA per min. |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1min. 10mA |
| Primary to F.G. | 2121VDC for 1 minute | |
| Output to F.G. | 2121VDC | |
| Insulation Resistance | Primary to secondary | >10M OHM 500 VDC |
| Primary to F.G. | >10M OHM 500 VDC |
Input
| AC Input Voltage Range | 90 to 264 VAC |
| Leakage Current | 0.25 mA max for 264V AC <50Hz for Input to PE |
| AC Input Frequency | 47-63 Hz |
| AC Inrush Current | 15A (RMS) mx for 115VAC/20A (RMS)max.for230 VAC |
| AC Input Current | 15A (RMS) mx for 115VAC/20A (RMS)max.for230 VAC |
General
| Efficiency | 75% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 16mS min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V maximum zener clamp |
EMC
| Conducted & radiated Emission | FCC Part 15 Class B | ||||||||||||||
| EN55022 Class B | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation -20 to +55°C Non-operation -40 to +85°C |
| Humidity |
| Operation 10 to 90% |