   |
|
POE20U-560G
Single Port 19.6W Midspan PoE Injector
Beschreibung
Phihong’s POE20U-560(G) is a 19.6W Single-Port midspan injector, compliant to the IEEE802.3af standards. This midspan injector is suitable for powering both PoE enabled devices and non-PoE enabled devices, with the use of a PoE splitter, via a Cat5/Cat5e/ Cat 6 cable into 10/100/1000 Base T systems.
Eigenschaften
Applications
| IP Telephones / IP Print Servers | Blue Tooth Access Point |
| Wireless Network Access Points | Security Camera |
Features
| Fully Compliant with IEEE802.3af | UNH IOL Test Report; Gigabit Compatible |
| Diagnostic LEDs; Non-Vented Case | Full Protection OTP, OCP, OVP |
Output
| DC Output Voltage | 56 V |
| Load | Min. 0A / Max. 0.35A |
| Regulation | Line / Load: ± 4% |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1min. 10mA |
| Primary to F.G. | 2121VDC for 1 minute | |
| Output to F.G. | 2121VDC | |
| Insulation Resistance | Primary to secondary | >10M OHM 500 VDC |
| Primary to F.G. | >10M OHM 500 VDC |
Input
| AC Input Voltage Range | 90 to 264 VAC |
| Leakage Current | 1.0mA max @ 254 VAC 60 Hz |
| AC Input Frequency | 47-63 Hz |
| AC Inrush Current | 15A (RMS) max for 115VAC/20A (RMS)max.for230 VAC |
| AC Input Current | 0,75A for 90VAC / 0,45A for 240VAC |
General
| Efficiency | 65% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 16mS min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V max. at switch on and off at any AC line Phase |
| Ripple and Noise | <500Hz (Vp-p:0,5mV); 500Hz-150KHz (Vp-p:0,15mV) |
| 150KHz-500KHz (Vp-p:0,15mV); 500KHz-1MHz (Vp-p:0,1mV) |
EMC
| Conducted & radiated Emission | FCC Part 15 Class B | ||||||||||||||
| EN55022 Class B | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation 0 to +40°C Non-operation -25 to +65°C |
| Humidity |
| Operation 10 to 90% |