   |
|
POE576U-4MP
Multi Port 95W Midspan PoE injector
Beschreibung
Phihong’s multi output gigabit PoE midspan POE576U-4MP series are fully complaint to IEEE802.3at standards. Models with 8, 16 or 24 ports are available. Each product can fully provide 95W per port over Cat5/Cat5e/Cat6 cables, eliminating the need for power management and prioritization. The midspans have Cisco legacy detection without the need of external dongles, as well as an optional NIC interface. Each product is provided with a Phihong graphics user interface (GUI) for diagnostics or remote control via the USB port on the standard model.
Eigenschaften
Applications
| Wireless Access Points; Security Systems; IP Cameras | Computer Workstations; Kiosks; Magnetic Locks |
Features
| Proprietary Detection, Disconnect & Overload Protection | Fully Compliant Detection, Disconnect&Voltage Control IEEE802.3af |
| Optional SNMP Management; Gigabit Compatible | 1U Rack Mountable by using mounting kit |
| Mega PoE 95W per Port | Full Protection OCP, OVP |
| Diagnostic LEDs; Limited Power Source | Fully Compliant Detection, Disconnect&Voltage Control IEEE802.3af |
Output
| POE576U-4MP | 4 Ports |
| Total Output Power | 95 W per port / 380W total maximum |
| Ripple and Regulation | 250mV maximum |
| Option: (X) | = N for SNMP Management |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1 minute |
| Primary to F.G. | 2121VDC for 1 minute | |
| Secondary to F.G. | 2121VDC for 1 minute |
Input
| AC Input Voltage Range | 90 to 264 VAC |
| AC Input Frequency | 47-63Hz |
| AC Input Current | 9A (RMS) mx for 90 VAC / 4.5A (RMS)max. for230 VAC |
| Leakage Current | 3.5mA maximum @ 264VAC 60Hz |
| AC Inrush Current | 30A (RMS) max. for 115VAC/ 60A (RMS)max. for230 VAC |
| Input Connector | AC Input IEC320 C14 |
General
| Efficiency | 75% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 16mS min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V max. at switch on and off at any AC line Phase |
| Turn-On Delay Time | 20sec max. at max. load, and 120VAC 60Hz, 60Hz |
| IEEE 802.3af/at Interoperability | If 25kohm is detected the unit operates in “IEEE802.3at mode” 33.6W 2 pair powering. 12.5k detection resistance required for full power UNH Interoperability report available upon request |
EMC
| Conducted & radiated Emission | EN55022 Class A, FCC Class A with UTP cabling | ||||||||||||||
| EN55022 Class B, FCC Class B with FTP cabling | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation 0 to +40°C Non-operation -25 to +65°C |
| Humidity |
| Operation/ Non-operation 5 to 90% |