   |
|
POE125U-4AT, POE125U-4ATN
Multiport 36W per Port Midspan PoE Injector
Beschreibung
Phihong’s POE125U-4HP is a low cost 4-Port High Power midspan injector. It is functionally compliant to the IEEE802.3af standards. This midspan injector can fully provide 36W per port over Cat5e/Cat6 cables into 10/100/1000 BaseT systems, eliminating the need for power management and prioritization.
Eigenschaften
Applications
| IP Telephones; Wireless Network Access Points | Blue Tooth Access Point; Security Cameras |
Features
| Fully Compliant with IEEE802.3af | 10/100/1000 base T compatible; Full ProtectionOCP, OVP |
| Full Power of 125W - (36 W per port) | Cisco AP1250 Full Power Support; rack mount possible |
| Cisco: no extern parts required for Legacy devices: | VoIP Phones (7910, 7912, 7940, 7960) |
| Access points (350, 1100, 1200) |
Output
| DC Output | 56V @ 36W per port |
| Regulation | Functional requirements of IEEE802.3af |
Safety
| Isolation Test | Primary to Secondary | 4242VDC for 1min. 10mA |
| Primary to F.G. | 2121VDC for 1 minute | |
| Output to F.G. | 2121VDC for 1 minute | |
| Insulation Resistance | Primary to secondary | >10M OHM 500 VDC |
| Primary to F.G. | >10M OHM 500 VDC |
Input
| AC Input Voltage Range | 90 to 264 VAC |
| Leakage Current | 3.5 mA max @ 254 VAC 60 Hz |
| AC Input Frequency | 47-63 Hz |
| AC Inrush Current | 30A (RMS) max. for 115VAC/ 60A(RMS) max. for 230VAC |
| AC Input Current | 2.5A for 90VAC / 1.3A for 240VAC |
General
| Efficiency | 75% (typical) at max. load and 120VAC 60Hz |
| Hold-up Time | 10mS min. 120VAC and max. load |
| Transient O/P Voltage Protection | 60V max. at switch on and off at any AC line phase |
EMC
| Conducted & radiated Emission | FCC Class B | ||||||||||||||
| EN55022 Class B | |||||||||||||||
| Immunity EN50082-1 |
|
Environmental
| Temperature |
| Operation 0 to +40°C Non-operation -25 to +65°C |
| Humidity |
| Operation 5 to 90% |