Control  A/B Switches with any switch closure, relay,  or remote control system.
Works with all Dataprobe Remote Control systems

Dataprobe's Relay Controlled A/B Switches, (K-AB Series) permits automatic, remote or manual switching of a Common line between two circuits, A or B. Multiple relays are used to switch the following circuit types:

• D25: 25 Pin D Subminiature Connector, All Pins Switched.  Supports RS-232, RS-530
• D15: 15 Pin D Subminiature Connectors; All Pins Switched.  Supports T-1, AUI
• D9:  9 Pin D Subminiature Connector, All Pins Switched.  Supports Com Port Serial
• RJ8: 8 Position, 8 Wire Modular Jacks; All leads switched.
  Supports RJ48C, RJ48S, RJ45 and all 8 position modular jack specifications.
• BNC: BNC Type Co-Axial Connector, Female.
• HZ-BNC: Hi- frequency module, BNC Type Co-Axial Connector, Female - 50 or 75 ohm
• DS3: Same as above but with special Dual BNC Module, individual transmit and receive circuits 45 Mhz .
• T50: 50 Pin "Telco" Connector (Amphenol RJ-21X), All 50 pins supported

When the relays are in the relaxed position, the Common Port is connected to Port A (Position A). When a selected external control signals is supplied, the relays are energized and the Common Port is connected to Port B (Position B). The K-AB-T1 returns to the A Position when the de-energize conditions are met.

In addition to Contact Closure/Contact Open, the K-AB also supports DC voltage + or - . Simple jumper configuration selects the switching method.

Manual Toggle Switch Control
A front panel three position switch allows Automatic or Manual Control. In the AUTO position, the K-AB switches on the selected Control Signal. In the Manual A or B Position, these controls are locked out and the relays assume the selected position.

Status Indication
Two front panel LED's indicate switch status. Remote alarms or displays can be controlled by the K-AB status signals, form C relay contacts. Status contacts are connected on a 9 pin D'Subminiature Connector on the rear panel

Physical Dimentions
Height:2.75" Width:8.00"
Depth:6.25" Weight:1.20 lbs.

Power Source
UL Approved Wall Mounted Power Supply. 115 VAC 60 Hz.
International Versions: 105-240 VAC, 47-63Hz

External Control and Status Interface: 9 pin D Subminiature, Female

Available Models: